Aquatec Beluga 조립 지침 - 페이지 3
{카테고리_이름} Aquatec Beluga에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatec Beluga 4 페이지. Change of actuator
Aquatec Beluga에 대해서도 마찬가지입니다: 조립 지침 (4 페이지), 조립 지침 (2 페이지), 조립 지침 (3 페이지)
페이지 인쇄Assembly Instructions
Change of actuator Aquatec
5.
Remove the motor cable with gasket from the guiding.
6.
Push the actuator down again.
7.
Break the hooks of the motor bolt with the screw driver and remove the motor bolt.
8.
Now the actuator can be removed.
E.
ASSEMBLY
1.
Take the motor out of the packing.
2.
Replace the motor cable with gasket in the guiding.
3.
Carefully replace the gasket of the lid.
4.
Put the motor cable plugs on the connectors of the circuit board.
5.
Close the electronic casing with the lid. Make sure that the gasket is in a correct
position.
6.
Screw the lid on but please do not strip the screws!
7.
Put the new actuator in its position on the backrest. Now put in the new motor bolt
until it is engaged.
Status: 01.12.06 / Marketing
1470111 Change actuator Beluga
®
Beluga
Page 3 of 4
V/Allgemein/Montage/Montageanleitungen/Englisch
Beluga/Change actuator Beluga