Panasonic AG-CX10 매뉴얼 - 페이지 21

{카테고리_이름} Panasonic AG-CX10에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic AG-CX10 21 페이지.

Tally

With the default conﬁguration "Panasonic CX350" for the RCPv2 tally will be enabled on the camera from

the DB9 connector (EXT I/O) directly on the RCPv2 panel.

Integrating Tally directly via IP from Video Switchers

It is possible to integrate tally directly from a Video Switcher we have a Device Core for. In the case of a

ATEM Switcher the following steps needs to be taken to achieve Tally control on the camera:

Add an ATEM Device Core to the conﬁguration

Add actions to the Hardware Component "Controller" like illustrated below (remember to set "Hold

Down"

It is also recommend to enable Tally feedback on the "ID Tally" bar via the following action:

SKAARHOJ DEVICE CORES