Diamond H2O DCF6-100-100 설치, 운영 및 유지보수 매뉴얼 - 페이지 16

{카테고리_이름} Diamond H2O DCF6-100-100에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond H2O DCF6-100-100 18 페이지. Activated carbon water filter system

페이지 인쇄

5. CONTROL VALVE INSTRUCTIONS continued

5.6.3. MANUAL REGENERATION

Sometimes there is a need to regenerate the system sooner

than when the system calls for it, usually referred to as a

manual regeneration. There may be a period of heavy water

usage because of guests or a heavy laundry day.

To initiate a manual regeneration at the preset delayed regeneration time, simultaneously press ▲

and ▼ and release. The arrow will point to the word Regen, if a regeneration is expected tonight.

To cancel the regeneration simultaneously press ▲ and ▼ and release.

To initiate a manual regeneration immediately, simultaneously press ▲ and ▼ for three seconds.

The system will begin to regenerate immediately. The request cannot be cancelled.

Note: For softeners, if brine tank does not contain salt, fill with salt and wait at least two hours

before regenerating

5.6.4. SET TIME OF DAY

STEP 1U:

Press SET

STEP 2U:

Current time: Adjust hour with ▲ or ▼. With 60

Hz line frequency detection on power-up,

timekeeping is 12 hour with PM indicator. With

50 Hz line frequency detection on power-up,

timekeeping is 24 hour without the PM indicator.

Press SET to go to Step 3U.

Adjust minutes with ▲ or ▼. Press SET to exit

STEP 3U:

Set Time of Day.

5.6.5. POWER LOSS

Only the current time of day will need to be reset if power is

lost for greater than 8 hours. If power is lost while the system

is regenerating, the control will complete regeneration at the

point of interruption once power is restored.

5.6.6. ERROR MESSAGE

If "E1," "E2", "E3" or "E4" appears on the display contact

the OEM for help. This indicates that the valve did not

function properly.

N1022 Quality Drive

Diamond H2O

PO Box 170

Ph: (920) 757-5440 / (866) 757-9287 / Fax: (920) 757-5819

Greenville, WI 54942

Page 14