Diamond H2O DCF6-150-100 설치, 운영 및 유지보수 매뉴얼 - 페이지 10
{카테고리_이름} Diamond H2O DCF6-150-100에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond H2O DCF6-150-100 18 페이지. Activated carbon water filter system
5. CONTROL VALVE INSTRUCTIONS continued
5.4.
OEM GENERAL INSTRUCTIONS
The control valve offers multiple procedures that allow the valve to be modified to suit the needs of
the installation. These procedures are:
• OEM System Setup
• Installer Displays & Settings (either 1-99 Days between Regeneration option or 7-Day option)
• User Displays
These procedures can be accessed in any order. Details on each of the procedures are provided
below and on the following pages.
When in operation, normal user displays show the time of day or days remaining before
regeneration. When stepping through a procedure, if no buttons are pressed within five minutes
the display returns to a normal user display. Any changes made prior to the five minute time out
are incorporated.
To quickly exit Installer Displays & Settings or OEM Setup, simultaneously press SET and ▼. Any
changes made prior to the exit are incorporated.
To reinitialize the control valve, check to make sure the valve is in the User Display. Then
simultaneously press SET and ▼ or unplug power source plug (4-pin connector) on the circuit
board, wait 3 seconds and plug back in.
5.5.
OEM SYSTEM SETUP
STEP 1SS:
From normal mode, press the SET and ▲ buttons
simultaneously for 3 seconds and release. Then
press the SET and ▲ buttons simultaneously for 3
seconds and release.
Choose the desired program by pressing the ▲ or ▼
STEP 2SS:
buttons. Prior to selecting a program, verify the
correct valve body, main piston, regenerant piston,
and stack are being used, and that the injector or
injector plug(s) are in the correct locations. See
Valve Body Compliance Table in the WS1 and WS1.25
Drawings and Service Manual. Press SET button to
go to Step 3SS.
N1022 Quality Drive
Diamond H2O
/
PO Box 170
Ph: (920) 757-5440 / (866) 757-9287 / Fax: (920) 757-5819
/
Greenville, WI 54942
Page 8