Panasonic CF-U1 series 추가 정보 - 페이지 21

{카테고리_이름} Panasonic CF-U1 series에 대한 추가 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic CF-U1 series 25 페이지. Supplementary instructions for hspa modem
Panasonic CF-U1 series에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 추가 지침 매뉴얼 (12 페이지), 추가 지침 매뉴얼 (12 페이지), 추가 지침 매뉴얼 (8 페이지), 추가 지침 매뉴얼 (17 페이지)

페이지 인쇄
Panasonic CF-U1 series 추가 정보
Barcode Configuration Utility
Barcode Software Tool
Barcode Software Tool is for Barcode Key Emulator.
Emulator Prefix
1
Click [Barcode Software Tool].
2
Click [Configure] on the right of [Emulator Prefix].
The subsequent setting procedure is the same as the one for [Barcode Reader Prefix] in [Data Configuration]
(
page
19).
Note: There isn't a limitation of number of characters such as with 1D Barcode Reader.
Emulator Suffix
1
Click [Barcode Software Tool].
2
Click [Configure] on the right of [Emulator Suffix].
The subsequent setting procedure is the same as the one for [Barcode Reader Suffix] in [Data Configuration]
(
page
19).
Note: There isn't a limitation of number of characters such as with the 1D Barcode Reader.
Allow un-readable characters
This allows the user to restrict or allow all ASCII characters.
When the check mark is checked, all ASCII values (except HEX 00)
are part of the barcode scanned data. If you remove the check mark
from (A), all ASCII characters of a HEX value of 1F or less are
removed from the barcode scanned data.
Show AIM
If you add a check mark for (B), AIM Identification is showed at the
beginning of the scanned barcode data.
This can only be enabled if [AIM Symbology] is enabled in the [Data
Configuration] (
page
19).
A
B
21
C
D