Panasonic DMC-F3P 서비스 매뉴얼 - 페이지 37

{카테고리_이름} Panasonic DMC-F3P에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic DMC-F3P 47 페이지. User manual
Panasonic DMC-F3P에 대해서도 마찬가지입니다: 사양 (2 페이지), 기본 사용 설명서 (28 페이지)

페이지 인쇄

8.4.6.

USB STORAGE INFO. REGISTRATION

[ PREPARATION ]

1. Perform the "8.3 Execute the Adjustment software"DscCalDi.exe"" in advance.

[ SETUP ]

1. Click on "Get" button.

(The USB Strage data is displayed.)

2. Confirm that the following data is displayed in each frame.

If not, revise the data as follows.

* "VID" frame : "MATSHITA"

* "PID" frame : "DMC-F3" ----(For DMC-F3), "DMC-F4" ----(For DMC-F4).

* "Rev" frame : "1.00"

3. Change the data in "Serial" frame from "00000000000"(11 digit) into the serial number.

(The serial number (it consists of 11 digit) is printed on the nameplate which is putted on the bottom side of the Unit.)

NOTE:

To change the data, delete data first, then enter the data.

4. Click on "Set" button, which is located on just below the "Get" button.

[ AFTER SETTING-UP ]

1. Close the "DscCalDi.exe" by clicking on the "X" located on the top right corner.

The LCD of the Camera unit becomes black fade.

2. Turn "off" the power switch of the camera unit.

3. Disconnect the USB cable.