Aquatec Equipment EV4910LV-DC 사용 설명서 - 페이지 10

{카테고리_이름} Aquatec Equipment EV4910LV-DC에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatec Equipment EV4910LV-DC 13 페이지. Low voltage submersible water pump & dc power supply

페이지 인쇄

TROUBLESHOOTING

Problem

WATER PUMP

NOT WORKING

WATER PUMP

IS NOISY

PMAX EVOII 1910_2910_3910_4910 DC Pump Instructions.indd 10

Reason

No Power

Sponges and filter media blocked with

sludge.

Impellor is blocked with sludge or lime

scale build up.

Running without sufficient water.

Blocked Impellor chamber or

ceramic shaft is broken.

Blockage in pump.

Impellor & Shaft worn out.

Impellor broken.

Water valve closed on the inlet or outlet.

Unit inlet is blocked or the water pump

outlet is blocked.

The height to which you are pumping is too

high for the given model of pump.

A Q U A T E C E Q U I P M E N T . C O M

Solution

Check that the plug is connected and

power point turned on.

Clean the sponges and filters.

Clean the Impellor as per the instructions.

Submerse the equipment underwater

then plug in. Refill if necessary.

Clean the Impellor. Check for wear.

Replace if necessary.

Clear the blockage.

Replace Impellor & Shaft.

Replace Impellor.

Open the valve and allow.

Clear all blockages.

Select a bigger model.

22/12/16 7:33 am