Diamond Lustre COBRA-H-DLC 운영자 매뉴얼 - 페이지 5
{카테고리_이름} Diamond Lustre COBRA-H-DLC에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Lustre COBRA-H-DLC 11 페이지.
페이지 인쇄BECOME FAMILAR WITH YOUR NEW EXTRACTOR
1
2
3
4
5
10
6
9
7
8
MACHINE DESCRIPTIONS
Operator Handle (1) - Operator holds this to move the machine from one location to another.
Solution Tank Lid (2) - Fill Solution Tank here with warm water and chemicals.
Switch Plate (3) - This is where the switches are located that operate the pump, vacuum and heater.
Recovery Tank Lid (4) - The Recovery Tank can be flushed out by running clean water into this opening
with the Drain Gate (7) open. The vacuum float Shut-OFF can also be accessed through this opening for
maintenance.
Vacuum Inlet (5) - This is where the vacuum hose attaches to the machine.
Latch (6) - Open the latches to access the base compartment, which contains the motors and heater.
Drain Gate (7) - Open this gate to drain the recovered solution out of the machine. Be sure to keep this
gate clean.
Castor (8) - The castor swivels for easy maneuvering in tight spots.
Wheel (9) - Large, non-marking wheels for ease of transport.
Power Cords (10) - Two, 25 foot cords, rated 12 gauge, 3 wire. Do not use if either cord is damaged.
The cord with the red sleeve operates the vacuum and the pump. The other cord operates the heat
exchanger.
5
COBRA-H-DLC
09/2003