HP 10508 데이터시트 - 페이지 8

{카테고리_이름} HP 10508에 대한 데이터시트을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 10508 20 페이지. 10500 series
HP 10508에 대해서도 마찬가지입니다: 사양 (42 페이지)

페이지 인쇄

1. Product Overview

Data sheet | HP 10500 Switch Series

• RIP next generation (RIPng)

Extends RIPv2 to support IPv6 addressing

• OSPFv3

Provides OSPF support for IPv6

• IS-IS for IPv6

Extends IS-IS to support IPv6 addressing

• BGP+

Extends BGP-4 to support multiprotocol BGP, including support for IPv6 addressing

• MPLS

Uses BGP to advertise routes across label switched paths (LSPs), but uses simple labels

to forward packets from any L2 or L3 protocol—which reduces complexity and increases

performance; supports graceful restart for reduced failure impact; and provides support for

LSP tunneling and multilevel stacks

• MPLS L3 VPN

Allows L3 VPNs across a provider network; uses MP-BGP to establish private routes for

increased security; and supports RFC 2547bis multiple autonomous system VPNs for added

flexibility

• MPLS L2 VPN

Establishes simple L2 point-to-point VPNs across a provider network, using only MPLS label

distribution protocol (LDP); requires no routing—which decreases complexity, increases

performance, and allows VPNs of non-routable protocols; uses no routing information for

increased security; and supports circuit cross connect, static virtual circuits, a Martini draft,

and Kompella-draft technologies

• Virtual private LAN service (VPLS)

Establishes point-to-multipoint L2 VPNs across a provider network

• Super VLAN

Saves IP address space, using RFC 3069 standard also called VLAN aggregation

• ECMP

Enables multiple equal-cost links in a routing environment to increase link redundancy and

scale bandwidth

• IPv6 tunneling

Provides an important element for the transition from IPv4 to IPv6; allows IPv6 packets to

traverse IPv4-only networks by encapsulating the IPv6 packet into a standard IPv4 packet;

supports manually configured, 6-to-4, intra-site-automatic-tunnel-addressing-protocol

(ISATAP) tunnels, and IPv6 VPN provider-edge router tunnel

Security

• ACL enablement

Supports powerful ACLs for both IPv4 and IPv6; and helps filter traffic to prevent unauthorized

users from accessing the network or control network traffic in order to save resources; rules

can either deny or permit traffic to be forwarded; rules can be based on an L2 header or an L3

protocol header; and rules can be set to operate on specific dates or times

• Remote authentication dial-in user service (RADIUS)

Eases switch security access administration by using a password authentication server

• Terminal access controller access-control system (TACACS+)

Delivers an authentication tool, using TCP with encryption of the full authentication request,

providing additional security