HP 12500 Series 명령 참조 매뉴얼 - 페이지 15
{카테고리_이름} HP 12500 Series에 대한 명령 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 12500 Series 34 페이지. 20gbps vpn firewall module
HP 12500 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지)
페이지 인쇄An IRF link down report delay helps avoid link flapping causing frequent IRF splits and merges
during a short time.
An IRF port handles link down and link up events, as follows:
When the IRF link changes from up to down, the port does not immediately report the change
•
to the IRF fabric. If the IRF link state is still down when the delay time is reached, the port
reports the change to the IRF fabric.
When the IRF link changes from down to up, the link layer immediately reports the event to
•
the IRF fabric.
Examples
# Set the IRF link down report delay to 300 milliseconds.
<Sysname> system-view
[Sysname] irf link-delay 300
irf link-status detect enable
Use irf link-status detect enable to enable IRF link failure detection.
Use undo irf link-status detect enable to disable this function.
Syntax
irf link-status detect enable
undo irf link-status detect enable
Default
The IRF link failure detection is enabled.
Views
System view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
This command is available in IRF mode. Changing the operating mode from IRF to standalone can
cause loss of the undo irf link-status detect enable command configuration, even if you have
saved the configuration.
After the IRF link failure detection is enabled, the system automatically examines the status of each
IRF physical link to discover IRF link failure events.
Examples
# Disable the IRF link failure detection.
<Sysname> system-view
[Sysname] undo irf link-status detect enable
irf link-status auto-recovery enable
Use irf link-status auto-recovery enable to enable the IRF link failure auto recovery.
12