HP 12500 Series 명령 참조 매뉴얼 - 페이지 20

{카테고리_이름} HP 12500 Series에 대한 명령 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 12500 Series 34 페이지. 20gbps vpn firewall module
HP 12500 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지)

페이지 인쇄

Syntax

irf member member-id renumber new-member-id

undo irf member member-id renumber

Default

In IRF mode, the device by default uses the member ID set by using the irf member command.

Views

System view

Predefined user roles

network-admin

mdc-admin

Parameters

member-id: Specifies the ID of an IRF member device, in the range of 1 to 4.

new-member-id: Assigns a new ID to the IRF member device, in the range of 1 to 4.

Usage guidelines

CAUTION:

In IRF mode, an IRF member ID change can invalidate member ID relevant settings

(including interface and file path settings) and even cause data loss. Be sure you fully

understand its impact on your live network.

Before enabling IRF mode, you must use the irf member command to assign a unique member ID

to each member device in standalone mode. If two member devices have the same member ID,

they cannot join the same IRF fabric.

After IRF mode is enabled, change member IDs before making any other configuration.

After an IRF fabric is formed, make sure you understand the impact of the member ID change on

your network.

The new IRF member ID, including the one set by using the undo irf member renumber command,

takes effect after you reboot the member device.

To cancel the change before you reboot the member device, use the undo irf member renumber

command. This command loses effect after you reboot the member device.

Examples

# Change the member ID of an IRF member from 2 to 4.

<Sysname> system-view

[Sysname] irf member 2 renumber 4

Renumbering the member ID may result in configuration change or loss. Continue?[Y/N]y

# Before rebooting the device, cancel the change in the preceding example.

[Sysname] undo irf member 2 renumber

Renumbering the member ID may result in configuration change or loss. Continue?[Y/N]y