HP 12500 Series 명령 참조 매뉴얼 - 페이지 32

{카테고리_이름} HP 12500 Series에 대한 명령 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 12500 Series 34 페이지. 20gbps vpn firewall module
HP 12500 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지)

페이지 인쇄

Default

No physical ports are bound to any IRF port.

Views

IRF port view

Predefined user roles

network-admin

mdc-admin

Parameters

mdc mdc-id: Specifies the ID for an MDC, in the range of 1 to 4. If an MDC is specified, this

command binds physical ports on the MDC to an IRF port. If no MDC is specified, this command

binds physical ports on the default MDC to an IRF port.

interface-type interface-number: Specifies a physical port by its type and number.

interface-name: Specifies a physical port in the interface-typeinterface-number format. No space is

allowed between the interface-type and interface-number arguments.

Usage guidelines

The MDC settings may lose effect after the device reboots to join an IRF fabric. HP recommends

creating an MDC and binding its physical ports to an IRF port after the IRF fabric is formed. For

more information about MDC, see Fundamentals Configuration Guide.

In IRF mode, use the shutdown command to shut down the physical port before binding it to the

IRF port or removing it from the IRF port. After the binding operation is complete, use the undo

shutdown command to bring up the physical port, and execute the irf-port-configuration active

command to active the IRF port configuration. After the binding removal operation is complete, use

the undo shutdown command to bring up the physical port.

In standalone mode, the shutdown and undo shutdown operations are not required.

Repeat the port group interface command to bind up to 12 physical ports to an IRF port for link

redundancy.

The system does not dynamically remove the binding between a physical port and an IRF port,

even if the IRF link has been lost, for example, because the interface card holding the physical port

is removed. To remove the binding, first shut down the physical port and then use the undo port

group interface command. If the interface card holding the physical port is removed, you do not

need to execute the shutdown command before removing the binding.

Examples

# In standalone mode, bind port Ten-GigabitEthernet 2/0/1 to IRF-port 1.

<Sysname> system-view

[Sysname] irf-port 1

[Sysname-irf-port1] port group interface ten-gigabitethernet 2/0/1

# In IRF mode, bind port Ten-GigabitEthernet 1/2/0/1 to IRF-port 1 of member 1.

<Sysname> system-view

[Sysname] interface ten-gigabitethernet 1/2/0/1

[Sysname-Ten-GigabitEthernet1/2/0/1] shutdown

[Sysname-Ten-GigabitEthernet1/2/0/1] quit

[Sysname] irf-port 1/1