HP 1410-24-R 시작하기 매뉴얼 - 페이지 5
{카테고리_이름} HP 1410-24-R에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 1410-24-R 21 페이지. 1410 switch series
HP 1410-24-R에 대해서도 마찬가지입니다: 사양 (33 페이지), 사양 (33 페이지), 빠른 설정 매뉴얼 (2 페이지)
페이지 인쇄
Preparing for installation
Safety recommendations
WARNING!
Before installation and operation, read all of the safety instructions in the
supplied with your device.
Safety symbols
When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.
General safety recommendations
To avoid any equipment damage or bodily injury caused by improper use, read the following safety
recommendations before installation. Note that the recommendations do not cover every possible
hazardous condition.
Do not place the switch on an unstable case or desk. The switch might be severely damaged in case
•
of a fall.
•
Make sure the ground is dry and flat and anti-slip measures are in place.
Keep the chassis and installation tools away from walk areas.
•
Keep the chassis clean and dust-free.
•
Do not place the switch near water or place it in a damp environment. Prevent water or moisture
•
from entering the switch chassis.
To prevent condensation, unpack the switch at least half an hour after you move the switch from a
•
location below 0°C (32°F) to the equipment room. Power on the switch at least 2 hours after you
move the switch from a location below 0°C (32°F) to the equipment room.
Ensure proper ventilation of the equipment room, and keep the air inlet and outlet vents of the switch
•
free of obstruction.
Make sure the operating voltage is in the required range.
•
Use a screw driver to fasten screws.
•
2
Compliance and Safety Guide