HP 1620-48G 시작하기 매뉴얼 - 페이지 13
{카테고리_이름} HP 1620-48G에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 1620-48G 27 페이지.
페이지 인쇄
NOTE:
To disconnect the console cable, remove the RJ-45 connector of the cable and then the DB-9 female
connector.
Connecting the AC power cord
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Connect one end of the grounding cable to the grounding screw on the rear panel, and connect
the other end to the ground.
Make sure the correct power source is used.
3.
4.
Connect one end of the AC power cord to the AC power receptacle on the switch.
5.
Connect the other end of the AC power cord to the AC power outlet.
6.
Examine the power LED. If it is ON, the power connection is correct.
Figure 12 Connecting the AC power cord to the AC power receptacle
Verifying the installation
After you complete the installation, verify the following items:
There is enough space for heat dissipation around the switch.
•
The rack or workbench is stable.
•
The grounding cable is securely connected.
•
The correct power source is used.
•
The power cords are correctly connected.
•
All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket
•
strip with lightning protection and lightning arresters for network ports have been correctly
connected.
9