HP 1810-48G 빠른 설정 매뉴얼 - 페이지 2

{카테고리_이름} HP 1810-48G에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 1810-48G 5 페이지. Smart-managed, fixed-configuration gigabit and fast ethernet layer 2 switches
HP 1810-48G에 대해서도 마찬가지입니다: 빠른 사양 (25 페이지), 사양 (32 페이지), 빠른 사양 (32 페이지), 데이터시트 (11 페이지)

페이지 인쇄

Install the Switch Hardware (Continued)

Wall or Under-Table: Use a #1 Phillips (cross-head) screwdriver

to attach the supplied brackets to the switch using the eight 8-mm

M4 screws in the orientation shown.

For wall-mounting, the network ports must be facing up or down.

Do not mount the switch with ventilation or fan ducts facing up or

down. (See "Installation Precautions" on page 4.)

Attach the switch to the wall or wood surface with four 5/8-inch

number 12 wood or tap screws (not included).

. Power On the Switch.

Configure the switch for operation on your network

(minimal configuration).

Using a standard Ethernet cable, connect a PC directly to the

switch.

Then configure the PC's IP Address and Subnet Mask to allow it to

communicate with the switch through your PC's Web browser.

Switch factory-default settings:

Parameter

Factory Default Setting

Password

<blank>

IP address

192.168.2.10

Subnet mask

255.255.255.0

Default gateway

not set

See the example on page 3.

. Connect Network Cables.

Note: For transceiver connections, install and use only

HP mini-GBIC/SFP transceivers supported by the switch.

See "Mini-GBIC/SFP Installation Notes" on page 3.

5/8-inch #12

screws

Connect to

any port