HP 1910-48 시작하기 매뉴얼 - 페이지 23

{카테고리_이름} HP 1910-48에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 1910-48 26 페이지. 1910 switch series
HP 1910-48에 대해서도 마찬가지입니다: 빠른 사양 (43 페이지), 데이터시트 (16 페이지), 빠른 사양 (44 페이지)

페이지 인쇄
HP 1910-48 시작하기 매뉴얼
Symptom
Unable to log on to the Web
interface of the HP 1910 switch
Troubleshooting method
1.
Use the ping command to check the network connectivity:
a.
Ping 127.0.0.1 to verify that TCP/IP has been installed.
b.
Ping the management IP address of the switch to verify that the
management PC is connected to the switch. If not, perform the
following check:
For local configuration, verify that the IP addresses of the
management PC and the switch are in the same subnet.
For remote configuration, verify that the route from the
management PC to the switch is reachable.
2.
Check the LED status to verify that the cables are connected
properly.
3.
Verify that the switch's port that connects to the management PC is
enabled and belongs to the management VLAN.
4.
Verify that the Web browser is not configured with proxy or dial-up
connection.
5.
Disable and then enable the local network after you complete local
network settings.
7