HP 1910-8-PoE+ 데이터시트 - 페이지 8

{카테고리_이름} HP 1910-8-PoE+에 대한 데이터시트을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 1910-8-PoE+ 16 페이지. 1910 switch series
HP 1910-8-PoE+에 대해서도 마찬가지입니다: 빠른 사양 (43 페이지), 빠른 사양 (44 페이지), 시작하기 매뉴얼 (26 페이지)

HP 1910-8-PoE+ 데이터시트
HP 1910 Switch Series
Specifications (continued)
Ports
Physical characteristics
Weight
Memory and processor
Mounting
Performance
100 Mb Latency
1000 Mb Latency
Throughput
Routing/Switching capacity
Routing table size
MAC address table size
Environment
Operating temperature
Operating relative humidity
Nonoperating/Storage temperature
Nonoperating/Storage relative humidity 10% to 95%, noncondensing
Electrical characteristics
Frequency
Voltage
Maximum power rating
Notes
Safety
Emissions
Management
Notes
Services
8
HP 1910-24G Switch (JE006A)
24 RJ-45 auto-negotiating 10/100/1000 ports (IEEE
802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX,
IEEE 802.3ab Type 1000BASE-T)
4 SFP 1000 Mbps ports
1 RJ-45 console port to access limited CLI port
Supports a maximum of 24 autosensing 10/100/1000
ports plus 4 1000BASE-X SFP ports, or a combination
17.4(w) x 6.3(d) x 1.7(h) in (44.2 x 16 x 4.32 cm) (1U
height)
6.8 lb (3.08 kg)
ARM @ 333 MHz, 128 MB flash, 128 MB RAM; packet
buffer size: 512 KB
Mounts in an EIA standard 19-inch telco rack or
equipment cabinet (hardware included)
< 5 µs
< 5 µs
up to 41.7 Mpps (64-byte packets)
56 Gb/s
32 entries (IPv4), 32 entries (IPv6)
8192 entries
32°F to 113°F (0°C to 45°C)
10% to 90%, noncondensing
-40°F to 158°F (-40°C to 70°C)
50/60 Hz
100-240 VAC
31.5 W
Maximum power rating and maximum heat dissipation
are the worst-case theoretical maximum numbers
provided for planning the infrastructure with fully
loaded PoE (if equipped), 100% traffic, all ports plugged
in, and all modules populated.
UL 60950; IEC 60950-1; EN 60950-1; CAN/CSA-C22.2 No.
60950-1-03
FCC part 15 Class A; VCCI Class A; EN 55022 Class A;
CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,
61000-3-3; ICES-003 Class A
IMC - Intelligent Management Center; limited
command-line interface; Web browser; SNMP Manager;
IEEE 802.3 Ethernet MIB
SFP ports and copper ports can work simultaneously,
independent of each other, to provide a total of 28
Gigabit Ethernet-capable ports.
3-year, 4-hour onsite, 13x5 coverage for hardware
(UV786E)
3-year, 4-hour onsite, 24x7 coverage for hardware
(UW485E)
HP 1910-16G Switch (JE005A)
16 RJ-45 auto-negotiating 10/100/1000 ports (IEEE
802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX,
IEEE 802.3ab Type 1000BASE-T)
4 SFP 1000 Mbps ports
1 RJ-45 console port to access limited CLI port
Supports a maximum of 16 autosensing 10/100/1000
ports plus 4 1000BASE-X SFP ports, or a combination
17.4(w) x 6.3(d) x 1.7(h) in (44.2 x 16 x 4.32 cm) (1U
height)
6.8 lb (3.08 kg)
ARM @ 333 MHz, 128 MB flash, 128 MB RAM; packet
buffer size: 512 KB
Mounts in an EIA standard 19-inch telco rack or
equipment cabinet (hardware included)
< 5 µs
< 5 µs
up to 29.8 Mpps (64-byte packets)
40 Gb/s
32 entries (IPv4), 32 entries (IPv6)
8192 entries
32°F to 113°F (0°C to 45°C)
10% to 90%, noncondensing
-40°F to 158°F (-40°C to 70°C)
10% to 95%, noncondensing
50/60 Hz
100-240 VAC
25.1 W
Maximum power rating and maximum heat dissipation
are the worst-case theoretical maximum numbers
provided for planning the infrastructure with fully
loaded PoE (if equipped), 100% traffic, all ports plugged
in, and all modules populated.
UL 60950; IEC 60950-1; EN 60950-1; CAN/CSA-C22.2 No.
60950-1-03
FCC part 15 Class A; VCCI Class A; EN 55022 Class A;
CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,
61000-3-3; ICES-003 Class A
IMC - Intelligent Management Center; limited
command-line interface; Web browser; SNMP Manager;
IEEE 802.3 Ethernet MIB
SFP ports and copper ports can work simultaneously,
independent of each other, to provide a total of 20
Gigabit Ethernet-capable ports.
3-year, 4-hour onsite, 13x5 coverage for hardware
(UV786E)
3-year, 4-hour onsite, 24x7 coverage for hardware
(UW485E)
HP 1910-8G Switch (JG348A)
8 RJ-45 auto-negotiating 10/100/1000 ports (IEEE
802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX,
IEEE 802.3ab Type 1000BASE-T)
1 SFP 1000 Mbps port
1 RJ-45 console port to access limited CLI port
Supports a maximum of 8 autosensing 10/100/1000
ports plus 1 1000BASE-X SFP ports, or a combination
8.27(w) x 8.27(d) x 1.72(h) in (21 x 21 x 4.36 cm) (1U
height)
4.41 lb (2 kg)
ARM @ 333 MHz, 128 MB flash, 128 MB RAM; packet
buffer size: 512 KB
Mounts in an EIA standard 19-inch telco rack or
equipment cabinet (hardware included)
< 5 µs
< 5 µs
up to 13.4 Mpps (64-byte packets)
18 Gb/s
32 entries (IPv4), 32 entries (IPv6)
8192 entries
32°F to 113°F (0°C to 45°C)
10% to 90%, noncondensing
-40°F to 158°F (-40°C to 70°C)
10% to 95%, noncondensing
50/60 Hz
100-240 VAC
14.4 W
Maximum power rating and maximum heat dissipation
are the worst-case theoretical maximum numbers
provided for planning the infrastructure with fully
loaded PoE (if equipped), 100% traffic, all ports plugged
in, and all modules populated.
UL 60950; IEC 60950-1; EN 60950-1; CAN/CSA-C22.2 No.
60950-1-03
FCC part 15 Class A; VCCI Class A; EN 55022 Class A;
CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,
61000-3-3; ICES-003 Class A
IMC - Intelligent Management Center; limited
command-line interface; Web browser; SNMP Manager;
IEEE 802.3 Ethernet MIB
SFP port and copper ports work simultaneously,
independent of each other, to provide a total of 9 Gigabit
Ethernet-capable ports.
Refer to the HP website at
www.hp.com/networking/services for details on the
service-level descriptions and product numbers. For
details about services and response times in your area,
please contact your local HP sales office.