HP 1910-8-PoE+ 시작하기 매뉴얼 - 페이지 18

{카테고리_이름} HP 1910-8-PoE+에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 1910-8-PoE+ 26 페이지. 1910 switch series
HP 1910-8-PoE+에 대해서도 마찬가지입니다: 빠른 사양 (43 페이지), 데이터시트 (16 페이지), 빠른 사양 (44 페이지)

페이지 인쇄
HP 1910-8-PoE+ 시작하기 매뉴얼

Connection procedure

To connect a terminal, for example, a PC, to the switch:
Plug the DB-9 female connector of the console cable to the serial port of the PC.
1.
Connect the RJ-45 connector to the console port of the switch.
2.
NOTE:
Identify the mark on the console port and make sure that you are connecting to the correct port.
•
•
The serial ports on PCs do not support hot swapping. If the switch has been powered on, connect the
console cable to the PC before connecting to the switch, and when you disconnect the cable, first
disconnect from the switch.

Setting terminal parameters

To configure and manage the switch, you must run a terminal emulator program on the console terminal.
The following are the required terminal settings:
Bits per second—38,400
•
•
Data bits—8
Parity—None
•
Stop bits—1
•
•
Flow control—None
Emulation—VT100
•
To set terminal parameters, for example, on a Windows XP HyperTerminal:
Select Start > All Programs > Accessories > Communications > HyperTerminal.
1.
The Connection Description dialog box appears.
Enter the name of the new connection in the Name field and click OK.
2.
Figure 24 Connection description
2