HP 5120-48G-PoE+ EI 구성 매뉴얼 - 페이지 28
{카테고리_이름} HP 5120-48G-PoE+ EI에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 5120-48G-PoE+ EI 39 페이지. Hp 5120 ei switch series
HP 5120-48G-PoE+ EI에 대해서도 마찬가지입니다: 데이터시트 (17 페이지)
페이지 인쇄
To configure ARP MAD:
Step
1.
Enter system view.
2.
Assign a domain ID to the IRF
fabric.
3.
Create a VLAN dedicated to
ARP MAD.
4.
Return to system view.
5.
Enter Ethernet interface view
or interface range view.
6.
Assign the port or the range
of ports to the ARP MAD
VLAN.
7.
Return to system view.
8.
Enter VLAN interface view.
9.
Assign the interface an IP
address.
10.
Enable ARP MAD.
Excluding a port from the shutdown action upon detection of
multi-active collision
Command
system-view
irf domain domain-id
vlan vlan-id
quit
•
Enter interface range view:
Method 1:
interface range { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5>
Method 2:
interface range name name
[ interface { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5> ]
•
Enter Ethernet interface view:
interface interface-type
interface-number
•
Assign the port to the VLAN as an
access port:
port access vlan vlan-id
•
Assign the port to the VLAN as a
trunk port:
port trunk permit vlan vlan-id
•
Assign the port to the VLAN as a
hybrid port:
port hybrid vlan vlan-id { tagged |
untagged }
quit
interface vlan-interface
interface-number
ip address ip-address { mask |
mask-length }
mad arp enable
24
Remarks
N/A
The default IRF domain ID is 0.
The default VLAN on the device
is VLAN 1.
N/A
To assign a range of ports to the
ARP MAD VLAN, enter interface
range view.
To assign one port to the ARP
MAD VLAN, enter Ethernet
interface view.
Choose one command
depending on the port type.
ARP MAD has no requirement
for the link type.
The default link type of a port is
access.
N/A
N/A
By default, no IP address is
assigned to any VLAN interface.
By default, ARP MAD is
disabled.