AQUATECH AquaBreak AB5 대상 지침 - 페이지 8
{카테고리_이름} AQUATECH AquaBreak AB5에 대한 대상 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUATECH AquaBreak AB5 18 페이지. Breaktank & pumpset for backflow protection to fluid category 5
페이지 인쇄Do not lift pumpset by pipework. Lift the pumpset by the container pallet using a pallet/forklift or
crane by passing strops underneath the skid using spreader bar.
Failure to utilise these facilities could result in damage.
1.3.2
LOCATION
If the set is to be installed in an unheated room, ensure that there is adequate frost protection.
The location of the equipment should have adequate drainage, bunding or other appropriate
measures to protect assets and the building fabric in the event of leakage or water spillage. Failure to
provide such measures may result in water damage to property and assets.
Ensure that location for pumpset provides adequate clear space to accommodate unit with reasonable
access to all parts; AquaTech‐Pressmain recommend a minimum distance of 500mm all round. There
must be sufficient room to: ‐
fully open panel door;
lift and withdraw pumps;
withdraw diaphragms from vessels.
Any Hydraulic Accumulator supplied should be located as near as possible to the discharge side of the
pumpset.
Should any of these location conditions not be satisfied AquaTech‐Pressmain reserve the right to
charge labour on any warranty work required on the pumpset.
1.3.3
FIXING
Lugs are provided for wall fixing on the back of the panel.
surface, in a location that is easily accessible. If floor mounted then install on a raised plinth to keep
set above damp floor.
Locate unit in position. If necessary, level by inserting packing strips adjacent to bolt positions. Firmly
attach pumpset to wall/base.
15mm mains water
Connection.1-3Bar
200mm
Deep
Fig. 1.2
AquaTech-Pressmain Instruction Manual\AquaBreak
Install the set on a flat, even and level
700/750
mm
High
300mm Wide
(630mm incl.
strainer &
overflow)
AquaBreak Series
230VAC single
phase 6A supply
Mains power switch
22mm Overflow
Warning pipe with
Quick release filter
22mm system
connection
Page 8 of 18