HP ProCurve 1810G-24 설치 및 시작하기 매뉴얼 - 페이지 9
{카테고리_이름} HP ProCurve 1810G-24에 대한 설치 및 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve 1810G-24 48 페이지. Procurve 1810g series
HP ProCurve 1810G-24에 대해서도 마찬가지입니다: 사양 (2 페이지), 안전 및 규제 정보 (2 페이지)
페이지 인쇄
■
When the FDx (full duplex) indicator LED is on, the port Mode LEDs turn
on for those ports that are operating at full duplex.
When the Speed indicator LED is on, the port Mode LEDs turn on for ports
■
operating at 1000 Mbps. The port Mode LEDs are off for ports operating
at 10 Mbps or 100 Mbps.
Switch Features
The features of the ProCurve Switch 1400-24G include:
■
24 auto-sensing 10/100/1000Base-T RJ-45 ports.
plug-and-play networking—all ports are enabled—just connect the
■
network cables to active network devices and your switched network is
operational.
■
IEEE 802.3ab Auto MDI /MDI-X on all twisted-pair ports, meaning that all
connections can be made using straight-through twisted-pair cables.
Cross-over cables are not required, although they will also work. The pin
operation of each port is automatically adjusted for the attached device:
if the switch detects that a 10/100 Mbps switch or hub is connected to the
port, it configures the port as MDI; if the switch detects that a 10/100 Mbps
end-node device is connected to the port, it configures the port as MDI-X.
■
automatic learning of the network addresses in each switch's 8000-
address forwarding table.
automatically negotiated full-duplex operation for all 10/100/1000Base-T
■
RJ-45 ports when connected to other auto-negotiating devices
■
the mini-GBIC ports always operate at full duplex. (1400-24G)
supports pass through (flooding) of spanning tree BPDUs so that
■
upstream devices on the network which support Spanning Tree Protocol
can detect loops that exist on the ProCurve Switch 1400 interface.
Switch Overview
Switch Hardware Features
1-3