HP ProCurve 6120G/XG 설치 지침

{카테고리_이름} HP ProCurve 6120G/XG에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve 6120G/XG 4 페이지. Ethernet blade switch
HP ProCurve 6120G/XG에 대해서도 마찬가지입니다: 설치 지침 (4 페이지), 자주 묻는 질문 (4 페이지), 브로셔 및 사양 (17 페이지)

페이지 인쇄

HP ProCurve

6120XG Blade Switch

Installation Instructions

for HP c-Class BladeSystem

The information contained herein is subject to change without notice. The

only warranties for HP products and services are set forth in the express

warranty statements accompanying such products and services. Nothing

herein should be construed as constituting an additional warranty. HP shall

not be liable for technical or editorial errors or omissions contained herein.

Microsoft is a U.S. registered trademark of Microsoft Corporation.

Part Number 539957-001

September 2009 (First Edition)

Overview

This card provides instructions for installing an HP ProCurve 6120XG

Blade Switch for c-Class BladeSystem in an HP c-Class BladeSystem

enclosure.

Kit contents

HP ProCurve 6120XG Blade Switch



Console cable (USB A to USB mini-AB)



Customer Support/Warranty booklet



License documentation



This document

IMPORTANT: Only use HP-approved pluggable SFP+ or SFP

optical transceiver modules or SFP+ direct attach cables. For

more information, see the QuickSpecs on the HP website

(http://www.hp.com/go/bladesystem/interconnects).

HP ProCurve 6120XG Blade Switch

Additional information

For more information on the association between the server blade

mezzanine connectors and the interconnect bays, see the HP

BladeSystem enclosure setup and installation guide that ships with

the enclosure. During server blade installation, the location of the

mezzanine card determines the installation location of the switch

modules.

For specific switch port connection information for each blade, see

the HP BladeSystem enclosure setup and installation guide that ships

with the enclosure. Connections differ by blade type.

Installation guidelines

Observe the following guidelines:



All HP ProCurve switches in the enclosure require valid and

unique IP addresses before they can be accessed via Ethernet.

By default DHCP is enabled on these switches, so the switch

management interface can get IP credentials from the DHCP

server on the attached Ethernet network. If EBIPA is enabled on

the Onboard Administrator (OA) of the enclosure, OA will

assign an IP address to the switch from its configured IP

address range, so that switch can be accessed from the OA

Ethernet interface. If EBIPA is disabled but DHCP service is

available on the network attached to the OA Ethernet interface,

then the switch gets its IP address assigned from the attached

network. Any IP host on that network can access the switch at

this point. If the DHCP service is not available on the attached

network, the user can assign valid IP credentials from the