HP ProCurve Gig-T vl Module 설치 매뉴얼 - 페이지 16

{카테고리_이름} HP ProCurve Gig-T vl Module에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve Gig-T vl Module 48 페이지. Hp procurve switch vl modules

ProCurve Switch vl Modules

Installing the Modules

C a u t i o n

Use only supported genuine ProCurve mini-GBICs with your switch. Non-

ProCurve mini-GBICs are not supported, and their use may result in product

malfunction. Should you require additional ProCurve mini-GBICs, contact

your ProCurve Networking Sales and Service Office or authorized dealer.

Installing the mini-GBICs:

Hold the mini-GBIC by its sides and gently insert it into any of the slots in the

module until the mini-GBIC clicks into place.

Figure 6. Installing/removing a mini-GBIC

Removing the mini-GBICs:

The network cable should be disconnected from the mini-GBIC before

removing it from the module.

Depending on when you purchased your ProCurve mini-GBICs, it may have

either of three different release mechanisms: a metal latch, a wire bail, or a

plastic collar around the mini-GBIC.

To remove the mini-GBICs that have the plastic collar, push in the plastic collar

toward the switch until you see the mini-GBIC release from the switch (you

can see it move outward slightly), and then pull the mini-GBIC from the slot.

To remove the mini-GBICs that have the wire bail or metal latch, lower the

bail or latch until it is approximately horizontal, and then using the bail or

latch, pull the mini-GBIC from the slot.