HP ProCurve J4863A 설치 매뉴얼 - 페이지 30
{카테고리_이름} HP ProCurve J4863A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve J4863A 38 페이지. Switch gl modules
HP ProCurve J4863A에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 브로셔 (17 페이지)
페이지 인쇄
Port Type
10 Mbps Operation
100 Mbps Operation
1000 Mbps Operation
Cables
Twisted-Pair
Cable Specifications
Category 3, 4, or 5 100-ohm differential unshielded twisted-pair
(UTP) or shielded twisted-pair (STP) cable, complying with IEEE
802.3 10Base-T specifications, fitted with RJ-45 connectors
Category 5 100-ohm differential UTP or STP cable, complying
with IEEE 802.3u 100Base-TX specifications, fitted with RJ-45
connectors
Category 5E 100-ohm differential UTP or STP cable, complying
with IEEE 802.3ab 1000Base-T specifications, fitted with RJ-45
connectors
(please see "Note on 1000Base-T Cable Requirements", below)
Note on 1000Base-T Cable Requirements. The Category 5 networking
cables that work for 100Base-TX connections should also work for
1000Base-T, but for the most robust connections you should use cabling that
complies with the Category 5E specifications, as described in Addendum 5 to
the TIA-568-A standard (ANSI/TIA/EIA-568-A-5).
Because of the increased speed provided by 1000Base-T (Gigabit-T), network
cable quality is more important than for either 10Base-T or 100Base-TX.
Cabling plants being used to carry 1000Base-T networking must comply with
the IEEE 802.3ab standards. In particular, the cabling must pass tests for
Attenuation, Near-End Crosstalk (NEXT), and Far-End Crosstalk (FEXT).
Additionally, unlike the cables for 100Base-TX, the 1000Base-T cables must
pass tests for Equal-Level Far-End Crosstalk (ELFEXT), Multiple Disturber
ELFEXT, and Return Loss.
When testing your cabling, be sure to include the patch cables that connect
the switch and other end devices to the patch panels on your site. The patch
cables are frequently overlooked when testing cable and they must also
comply with the cabling standards.
Specifications
Maximum Length
100 meters
100 meters
100 meters
23