HP ProCurve J4864A 설치 매뉴얼 - 페이지 19

{카테고리_이름} HP ProCurve J4864A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve J4864A 36 페이지. Switch gl modules
HP ProCurve J4864A에 대해서도 마찬가지입니다: 설치 매뉴얼 (38 페이지)

페이지 인쇄

1. Descriptions

Customizing the Port Configuration

If the slot in which you installed the module was empty the last time the switch

was either rebooted or reset (or the power to the switch was cycled), then the

module will use preconfigured default parameter values that will work for

most networks.

The default port configurations for the modules are:

Ports Enabled: Yes

■

Mode:

•

10/100-TX GL Module: Auto — The port auto negotiates speed (10

or 100 Mbps), communication mode (half or full duplex), and MDI or

MDI-X port operation. Note: if you configure the port to one of the

fixed 100 Mbps modes, the port will then operate only as an MDI-X

port.

100/1000-T GL Module: Auto — The port auto negotiates speed

•

(1000 or 100 Mbps), communication mode (half or full duplex), and

MDI or MDI-X port operation. Note: if you configure the port to one

of the fixed 100 Mbps modes, the port will then operate only as an

MDI-X port.

•

Gigabit-SX and Gigabit-LX ports in Gigabit Transceiver GL

Module and mini-GBIC GL Module: Auto — The ports always

operate at 1000 Mbps and full duplex. The setting is Auto for best link

establishment with other devices.

Gigabit-LH ports in the mini-GBIC GL Module: Auto — The port

•

always operates at 1000 Mbps and full duplex. The setting is Auto for

best link establishment with other devices.

•

100-FX MTRJ GL Module: 100FDX — The port operates at 100 Mbps

and full-duplex communication mode.

Flow Control: Disabled

■

Advanced Features: Spanning Tree, Trunking, VLANs, Security, etc.: all

■

Disabled

If necessary, configure the port(s) in the module by using the switch console

or the web browser interface. For more information, see the Management and

Configuration Guide shipped on the documentation CD that came with the

switch, and the online Help provided in the console and web browser inter

faces.

If the default port configuration listed above is acceptable for your network,

then skip this process.

Installing the GL Modules