HP ProCurve J8766A 설치 매뉴얼 - 페이지 10
{카테고리_이름} HP ProCurve J8766A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve J8766A 48 페이지. Hp procurve switch vl modules
HP ProCurve J8766A에 대해서도 마찬가지입니다: 먼저 읽기 (4 페이지), 빠른 참조 매뉴얼 (44 페이지)
페이지 인쇄
ProCurve Switch vl Modules
Features
Link and Mode LEDs
4
Figure 3. Example: ProCurve Switch 1-port 10 Gig-X2 vl Module
The ProCurve Switch vl Modules have the following features:
auto-enabled ports—the ports are all configured to be ready for network
■
operation as soon as a viable network cable is connected
■
auto-configuration—a default configuration is applied to the module
when the switch is powered on and the module passes self test; this default
configuration works well for most network installations
LEDs that provide information for each port on the link status, network
■
activity, connection bandwidth (speed), communication mode (half or full
duplex), and presence of specific network error packets on the port
■
"hot swap modules" operation—you can add a module or replace a
module without having to shut down the switch (changing the module
type in a given slot does require a switch reset)
"hot swap mini-GBICs" operation—you can add, replace, or change the
■
type of any of the mini-GBICs that you use in any of the vl Modules that
use mini-GBICs, without having to first remove the module, and without
having to shut down the switch (you must remove the network cable
before hot-swapping a mini-GBIC)
■
"hot swap X2 transceiver" operation—you can add, replace, or change the
type of any of the X2 transceivers that you use in the 10-GbE vl Module,
without having to first remove the module, and without having to shut
down the switch (you must remove the network cable before hot-swap-
ping a transceiver)
port covers