HP ProLiant DL380 G4 DPSS 통합 참고 사항 - 페이지 17

{카테고리_이름} HP ProLiant DL380 G4 DPSS에 대한 통합 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProLiant DL380 G4 DPSS 26 페이지. Generation 4 (g4) packaged cluster with modular smart array 1000
HP ProLiant DL380 G4 DPSS에 대해서도 마찬가지입니다: 구현 매뉴얼 (35 페이지), 릴리스 정보 (21 페이지), 릴리스 정보 (8 페이지), 설치 지침 (2 페이지), 백서 (13 페이지), 구현 매뉴얼 (9 페이지), 빠른 사양 (48 페이지), 빠른 사양 (42 페이지), 설치 매뉴얼 (48 페이지)

페이지 인쇄

Windows Server 2008 installation for 32-bit and 64-bit

editions on ProLiant servers

Server deployment of Windows Server 2008 is supported through manual and assisted path

installation options. Use the steps below to complete a manual install of Windows Server 2008.

Pre-installation tasks

To prepare for installation, ensure that the following tasks are completed:

Select a server from the "ProLiant server platforms that support Windows Server 2008" section.

If necessary, select additional components from the "Supported components for ProLiant servers"

section

tables.

Go to

www.hp.com/go/bizsupport

installations for the server.

Use the ROM-Based Setup Utility (RBSU) to set date/time and configure the boot controller order

(if necessary).

Use the Array Configuration Utility to configure the RAID settings for the server.

Update iLO firmware to Version 1.42 (or later).

Install the HP Insight Management Agents only after SNMP is loaded and started.

NOTE

After installing Windows Server 2008 and before installing

the PSP, if installing HP Systems Insight Manager and agents,

make sure that SNMP is loaded and the service is started.

Installation procedure

To install Windows Server 2008 for 32-bit and 64-bit editions, complete the following steps:

Make sure that the server has a DVD drive (either native to the system or attached).

NOTE

A license key may be required to use iLO virtual media with HP

ProLiant ML or DL servers.

Place the Windows Server 2008 media into the DVD drive and boot the server to the DVD to

begin the installation.

to obtain the supported ROM for Windows Server 2008