Inserting Cage Nuts in the Rack
Before placing the Director into the rack, insert the cage nuts into the appropriate
locations along the exterior vertical rack rails. Read the following sections for
instructions on inserting front and rear cage nuts in the rack.
Inserting the Front Cage Nuts in the Rack
Use these steps to insert the six supplied cage nuts in the rack's front rails.
1. Select one of the exterior vertical rails at the front of the cabinet. From the bottom
of the shelf bracket, count up 3 U (9 holes) and insert the first of three cage nuts.
2. Count up 3 U (9 holes) from the cage nut you just installed and insert the next
cage nut.
3. Count up 3 U (9 holes) from the second cage nut and insert the third cage nut.
4. To install cage nuts in the other front rail, repeat
Inserting the Rear Cage Nuts in the Rack
Use these steps to insert the six supplied cage nuts in the rack's rear rails.
1. Select one of the exterior vertical rails at the rear of the cabinet. From the bottom
of the shelf bracket, count up 3 U (9 holes) and insert the first of three cage nuts.
2. Count up 4 U (12 holes) from the cage nut you just installed, and insert the next
cage nut.
3. Count up 4 U (12 holes) from the second cage nut and insert the third cage nut.
4. To install cage nuts in the other rear rail, repeat
Finalizing the Rack Mounting Procedure
Read the following sections to complete the installation procedure.
After completing the steps outlined in the previous section, prepare to orient the
Director 2/140 in the rack as follows. The procedure requires two technicians.
CAUTION: The Director 2/140 weighs approximately 167 lbs. Do not attempt to lift or
carry the Director 2/140 with fewer than two people. Failure to observe this CAUTION
may result in injury to personnel or damage to the Director 2/140.
director 2/140 rack mount kit installation instructions
Installation Instructions
step 1
through
step
step 1
through
step
3.
3.
9
페이지 인쇄