HP StorageWorks 2/16 - SAN Switch 릴리스 노트 - 페이지 12

{카테고리_이름} HP StorageWorks 2/16 - SAN Switch에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks 2/16 - SAN Switch 16 페이지. Fabric os commands
HP StorageWorks 2/16 - SAN Switch에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (9 페이지), 설치 지침 매뉴얼 (20 페이지), 사용자 설명서 (22 페이지), 펌웨어 릴리스 노트 (14 페이지), 릴리스 노트 (32 페이지), 설치 매뉴얼 (14 페이지), 릴리스 노트 (10 페이지), 빠른 참조 매뉴얼 (5 페이지)

Compatibility

Use of 62.5/125 should be restricted to situations where 62.5/125 optical fibre was

previously installed and the link lengths are to be kept shorter than 200 meters at

1 Gbps and shorter than 150 meters for 2 Gbps. Single-mode cables typically use

9/125 optical fibers for distances up to 10 km.

Compatibility

SAN Switch firmware v3.0.2k is compatible with the StorageWorks SAN Switch

software version 2.6.0h, allowing both 1 and 2 Gb switches to operate in the same

fabric.

For the latest supported configurations, please refer to the hp StorageWorks SAN

Design Reference Guide, part number AA-RMPNF-TE, available at

http://www.hp.com/country/us/eng/prodserv/storage.html.

Note:

supported with the SAN Switch 2/16.

The minimum supported firmware level for the StorageWorks Enterprise Virtual

Array by is VCS v1.02. The upgrade of the Enterprise storage subsystem

firmware must be performed before the upgrade of the switch firmware. Please

consult the Enterprise Virtual Array technical documentation for specific

information for upgrading VCS firmware.

The workstation used to manage a fabric and configure a switch must meet the

following requirements in order to install and run Web Tools. Web Tools is

installed and runs on the switch, but is displayed in a web browser running on the

workstation.

One of the following operating systems must be installed:

StorageWorks 1 Gb switch models running software version 1.6d are

Solaris 2.61 or later

Windows 95, 98, or 2000

Windows NT 4.0

SAN Switch 2/16 Version 3.0.2k Release Notes

not