HP StorageWorks 2/16 - SAN Switch 설치 매뉴얼 - 페이지 5

{카테고리_이름} HP StorageWorks 2/16 - SAN Switch에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks 2/16 - SAN Switch 14 페이지. Fabric os commands
HP StorageWorks 2/16 - SAN Switch에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (9 페이지), 설치 지침 매뉴얼 (20 페이지), 사용자 설명서 (22 페이지), 펌웨어 릴리스 노트 (14 페이지), 릴리스 노트 (32 페이지), 릴리스 노트 (16 페이지), 릴리스 노트 (10 페이지), 빠른 참조 매뉴얼 (5 페이지)

To install the switch in a rack:

1. Check contents of the shipping carton to verify all the required parts and

2. Choose a mounting location in the rack for the switch.

3. Attach the rear mounting brackets to the rear rack uprights by completing one

Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA

rack)

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

Caution:

For proper airflow, the SFP media side of the SAN Switch 2/32,

SAN Switch 2/16, or SAN Switch 2/8 must face the rear of the rack. This

mounting allows air to enter from the front of the rack and to exhaust at the

rear of the rack, similar to other rack-mounted equipment. This prevents switch

overheating, which may cause it to fail.

hardware are available.

of the following steps:

— For an HP 9000 Series or comparable EIA rack, assemble each of the two

brackets with (2) #10-32 x 1/2-inch Phillips pan-head screws with captive

star lock washers and (2) #10 adapter washers as shown in

Figure

Addendum Pg