HP StorageWorks 8/80 - SAN Switch 릴리스 노트 - 페이지 24

{카테고리_이름} HP StorageWorks 8/80 - SAN Switch에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks 8/80 - SAN Switch 29 페이지. Hp storageworks fabric os 6.1.2b release notes (5697-0351, march 2010)
HP StorageWorks 8/80 - SAN Switch에 대해서도 마찬가지입니다: 릴리스 노트 (30 페이지), 릴리스 노트 (43 페이지), 릴리스 노트 (32 페이지)

페이지 인쇄

HP StorageWorks 8/80 - SAN Switch 릴리스 노트

Fabric OS 6.1.1 fixes

Table 10

lists defects closed in the Fabric OS 6.1.1 firmware release.

Table 10 Fabric OS 6.1.1 closed defects

Closed defect summary

During storage failover/failback test, traffic stops and fails to recover

in single and dual backbone configurations.

A failure was detected in the MP Router blade (FR4–18i) due to a dead

heartbeat.

Link drops when FLOGI is received before the port comes online on

an FL_Port.

Internal server ports on an embedded platform; traffic may stop due

to loss of buffer credit.

Mixed fabric of McDATA and Brocade switches cannot be managed

if only IPv6 addressing is supported.

HBA is not following Fibre Channel protocol standards, which could

cause a switch reboot.

Problems in an IP network could cause a switch running Fabric OS

5.3.x to panic.

Device with slow initialization sequence may cause the switch to mis-

takenly establish virtual channels on an F_Port.

Web tools zoning breaks when third party storage virtualization appli-

ance is changed to standby mode leading to Web Tools hangs.

FICON tape write pipelining selectively resets after CmdRetry to

NoOp sequence to LBY, causing tape job failures.

F_Port link initialization failure exposed by new third-party device be-

havior, where switch continues to send idles after NOS from HBA.

SupportSave command using DCFM does not contain information

from the standby CP.

HP 400 Multi-Protocol Router sends the wrong sense code during tape

backup with pipelining enabled.

Web Tools: DCX blade attention LEDs on the switch view GUI window

do not turn amber when the blade needs attention.

FICON PTP VTS selective resets and aborted sequences are caused

by incorrect entry into FICON tape read pipelining.

After renaming a port group name to blank from Web Tools, the port

group is deleted.

If EE monitors are restored from flash on a switch that has TopTalker

monitors, there is no warning or error when the TopTalker monitor in-

stallation recovery fails.

Solution

Fixed in Fabric OS 6.1.1.

Fixed in Fabric OS6.1.1.

Fixed in Fabric OS 6.1.1.