HP StorageWorks 8B - FC Entry Switch 사용자 설명서 - 페이지 16

{카테고리_이름} HP StorageWorks 8B - FC Entry Switch에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks 8B - FC Entry Switch 44 페이지. Fabric os release notes version 3.0.1b
HP StorageWorks 8B - FC Entry Switch에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (9 페이지), 설치 지침 매뉴얼 (20 페이지), 사용자 설명서 (22 페이지), 펌웨어 릴리스 노트 (14 페이지), 설치 매뉴얼 (14 페이지), 릴리스 노트 (26 페이지), 매뉴얼 (50 페이지), 사용자 설명서 (44 페이지), 사용자 설명서 (38 페이지), 사용자 설명서 (38 페이지), 사용자 설명서 (37 페이지), 사용자 설명서 (30 페이지), 릴리스 노트 (16 페이지)

Using Zoning

In Figure 3-2, zone configurations are defined, enabled and saved to flash:

Figure 3-2

•

Disabling it. This deletes the effective configuration and saves the defined to flash. There is no

effective configuration in the flash at this point. To disable a configuration, use the

cfgDisable command.

Note:

Enabling a Zone Configuration

When a zone configuration is enabled, all zones within the configuration are enabled. All devices

within an enabled zone are visible to each other; however, they cannot communicate outside their

zone. Zones can overlap within a zone configuration.

When a zone configuration is enabled the following happens:

All aliases are expanded.

Inconsistencies are checked. If inconsistencies are discovered, an error occurs and the previous

state of the fabric is preserved. (For example, if zoning is disabled, it remains disabled; if an

existing configuration is enabled, it remains enabled.)

Switch hardware is loaded with the zoning information.

Zone members are loaded.

Registered State Change Notifications (RSCNs) are generated.

3-4

Defined

Enabled

Enable

Config1

Config2

Config3

Config4

Config5 (new)

Save directly to Flash

Enforced

Saving a Zone Configuration

Only the enabled configuration (in the shaded area) is enforced.

Saved

. . .then Save to Flash

Config1

Config2

Config3

Config4

Zoning User's Guide