HP zl2 빠른 설정 매뉴얼

{카테고리_이름} HP zl2에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP zl2 2 페이지. Internal power supplies
HP zl2에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지)

페이지 인쇄

zl Module-QSG.fm Page 1 Thursday, February 27, 2014 1:31 PM

HP zl2 Module Quick Setup Guide

The module drawings in this document are for illustration purposes only and may not match your module.

Load the most current switch software that 

supports your module. See Specifications.

Prepare for installation

To avoid personal injury or product damage, review the

"Installation precautions" on page 2.

Install the modules into a switch slot

The switch can be either powered on or off.

1 Insert module into the

guides and slide it in until

it is fully inserted.

Close the extractor handles to seat the

module, and tighten the retaining

screws until just snug.

Install optional transceivers

War n i n g : Avo i d di r e c t e y e e x po s u r e t o t h e b ea m

c o m i n g f r o m t h e t r an s m i t p o r t .

Verify self-test

1 Fault and Test LEDs = Off



See the Installation and Getting Started Guide for your

module. For example, a module with a standard RJ-45 LAN

port is illustrated in the following illustration.

2 Open extractor handles

N ot e : O p er a t i o n o f e a c h po r t 's L i n k an d M o d e

L E D s d e p e n d s o n t h e s w i t c h 's M o de s e l e c t i o n .

F o r i n f o r m a t i o n o n L E D be h a v i o r, s e e t h e HP

5 4 0 0 R z l 2 I n s t a l l at i o n a nd G et t i n g S t a r t e d G u i d e.

mini-GBIC or SFP

transceiver or SFP+

modules' ports

If the default port configuration is not appropriate for your

network application, configure the port(s) in the module by

using the switch console or the web browser interface. See

the HP 5400R zl2 Installation and Getting Started Guide for

information about connecting a console, and see the

Management and Configuration Guide for information

about configuring the switch and its ports.

For module documentation, go to the HP Networking website

2 Module Status LEDs = On

at: 

www.hp.com/networking/support.

Auto search on "zl modules," and select your module from the

list. Click Display selected, and then click on the links that

have Manuals listed to get on to the webpage that lists the

available manuals.

Connect network cables

Connect a fiber cable

Verify network connections

Link and Mode LED

(Optional) Customize the configuration for the