Panasonic U-20ME1E81 설치 지침 매뉴얼 - 페이지 16

{카테고리_이름} Panasonic U-20ME1E81에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic U-20ME1E81 28 페이지. Wall mounted (k1 type), mini vrf (le1 type), 2way vrf (me1 type), 3way vrf (me2 type)
Panasonic U-20ME1E81에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (24 페이지), 사용 설명서 (26 페이지), 사용 설명서 (25 페이지), 설치 지침 매뉴얼 (25 페이지), 설치 매뉴얼 (9 페이지), 사용 설명서 (10 페이지)

페이지 인쇄

How to connect wiring to the terminal

■ For stranded wiring

(1) Cut the wire end with cutting pliers,

then strip the insulation to expose

the stranded wiring about 10 mm and

tightly twist the wire ends. (Fig. 4-8)

(2) Using a Phillips head screwdriver,

remove the terminal screw(s) on the

terminal plate.

(3) Using a ring connector fastener or

pliers, securely clamp each stripped

wire end with a ring pressure terminal.

(4) Place the ring pressure terminal,

and replace and tighten the removed

terminal screw using a screwdriver.

(Fig. 4-9)

■ Examples of shield wires

(1) Remove cable coat not to scratch braided shield. (Fig.

4-10)

(2) Unbraid the braided shield carefully and twist the

unbraided shield wires tightly together. Insulate the shield

wires by covering them with an insulation tube or wrapping

insulation tape around them. (Fig. 4-11)

(3) Remove coat of signal wire. (Fig. 4-12)

(4) Attach ring pressure terminals to the signal wires and the

shield wires insulated in Step (2). (Fig. 4-13)

■ Electric Diagram for PAW-10EAIRC-MS and

PAW-10EAIRC-MJ

Fig. 4-14 shows the electric diagram for the PAW-10EAIRC-MS and PAW-10EAIRC-MJ models.

Stranded wire

Special

washer

Ring

pressure

terminal

Wire

Fig. 4-8

Screw

Ring pressure

terminal

Terminal plate

Wire

Fig. 4-9

Fig. 4-10

Insulation tape

Shield mesh

Fig. 4-11

Insulation tape

Shield mesh

Fig. 4-12

Fig. 4-13

Screw and

Special washer

Ring

pressure

terminal

Fig. 4-14