Panasonic WVBP554 - CCTV B/W CAMERA 사용 설명서 - 페이지 32
{카테고리_이름} Panasonic WVBP554 - CCTV B/W CAMERA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WVBP554 - CCTV B/W CAMERA 36 페이지. Super dynamic dsp b/w cameras
Panasonic WVBP554 - CCTV B/W CAMERA에 대해서도 마찬가지입니다: 사용 설명서 (36 페이지), 사양 (2 페이지)
페이지 인쇄
9. Special Menu (SPECIAL)
This menu lets you adjust and set up the video signal
of the camera to meet your requirements.
Move the cursor to END on the bottom line of the CAM
SET UP menu and press
2 seconds or longer. The SPECIAL menu appears on
the monitor as shown below.
** CAM SET UP **
CAMERA ID
OFF
ALC/ELC
ALC
SHUTTER
---
AGC
ON
SENS UP
OFF
SYNC
INT
MOTION DET
OFF
LENS DRIVE
DC
END
SET UP ENABLE
9-1. Camera Picture Upside Down Positioning
(UP SIDE DOWN)
1. Move the cursor to the UP SIDE DOWN parameter.
2. Select ON when you want to turn the picture
upside down.
or
simultaneously for
** SPECIAL **
UP SIDE DOWN
OFF
AP GAIN
....I....
PEDESTAL
.I.......
-
+
CAMERA RESET
PUSH SW
RET
END
-30-
9-2. Aperture Gain Setting (AP GAIN)
1. Move the cursor to the AP GAIN parameter.
2. While observing the vector scope or video monitor,
move the "I" cursor to adjust the aperture gain
level.
9-3. Pedestal Level Setting (PEDESTAL)
1. Move the cursor to the PEDESTAL parameter.
2. While observing the wave form monitor/oscillo-
scope or video monitor, move the "I" cursor to
adjust the pedestal level (black level).
To reset to the factory settings
1. Move the cursor to the CAMERA RESET parame-
ter. The words PUSH SW start blinking.
2. While holding down
seconds or longer. The camera is reset to the fac-
tory settings.
To close the SPECIAL menu and return to the CAM
SET UP menu
Move the cursor to RET and press
To close the SPECIAL menu and return to the
camera picture
Move the cursor to END and press
and
, press
for 2
.
.