Panasonic WVBP554 - CCTV B/W CAMERA 사용 설명서 - 페이지 31
{카테고리_이름} Panasonic WVBP554 - CCTV B/W CAMERA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WVBP554 - CCTV B/W CAMERA 36 페이지. Super dynamic dsp b/w cameras
Panasonic WVBP554 - CCTV B/W CAMERA에 대해서도 마찬가지입니다: 사용 설명서 (36 페이지), 사양 (2 페이지)
페이지 인쇄
6. To raise detection sensitivity, press
the MOTION DETECT menu.
7. To obtain the optimum detection level, move the
"I" cursor to adjust the level.
8. Repeat the procedures above to obtain a satisfac-
tory setting.
9. Move the cursor to RET and press
the CAM SET UP menu.
Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi-
tions:
• When shooting an object under flickering fluores-
cent light or shooting in ELC.
• When leaves or curtains etc. are swayed by the
wind.
• When the object is lighted by lighting equipment
that constantly turns on and off.
• It takes about 0.2 seconds for the alarm signal to
reach the alarm terminal of the VCR after the cam-
era detects the object.
Because the alarm signal is multiplexed on the
video signal, it may be mistakenly interpreted by
other video equipment as a time code signal.
Therefore, when camera is not used in a
Panasonic Intelligent CCTV System select OFF to
prevent the above from occurring.
8. Lens Drive Signal Selection (LENS
to return to
DRIVE)
This item is used to select the type of auto iris lens
drive signal to be supplied to the lens from the auto iris
lens connector.
to return to
1. Move the cursor to the LENS DRIVE parameter.
2. Select DC if you are using the auto iris lens that
requires a DC drive signal.
Select VIDEO if you are using the auto iris lens that
requires a video drive signal.
-29-
** CAM SET UP **
CAMERA ID
OFF
ALC/ELC
ALC
SHUTTER
---
AGC
ON
SENS UP
OFF
SYNC
INT
MOTION DET
OFF
LENS DRIVE
DC
END
SET UP ENABLE