aquatherm AT800 설치 매뉴얼 - 페이지 12

{카테고리_이름} aquatherm AT800에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aquatherm AT800 16 페이지. Swimming pool & spa heat pumps “black cabinet” with analog controls series only
aquatherm AT800에 대해서도 마찬가지입니다: 소유자 운영 매뉴얼 (12 페이지), 설치 매뉴얼 (8 페이지)

페이지 인쇄

Interfacing "Prologic" Analog Control Models with:

Jandy™ AquaLink RS, AquaSwitch, JI 2000 & Compool™

To interface the "Prologic" analog control heat pump models with the Jandy™ AquaLink RS

series or Compool, run a 2 wire (16 A.W.G. or larger) insulated cable from the device to the heat

pump. If you are using a Jandy AquaSwitch or JI2000 control use a 3 wire cable. Review wiring

diagram on page 10.

Remove the 6 screws from the heaters front service access panel and open. Look for a white,

two position wire terminal located inside the top portion of the electrical compartment and is

mounted on the rear wall. (Do not confuse it with the 4 position, white terminal block

above it !) Locate, remove and discard the orange wire loop attached at the bottom

end of this terminal. Then, attach the 2 wire cable coming from the AquaLink RS or the Compool

control to the 2 position terminal where the orange loop was prior, see page 13.

NOTE for AquaLink RS and

Compool: Turn both heater ther-

mostats all the way up and set

the mode selector switch to

pool and do not use the heater

controls as the Jandy or

Compool now has thermostat

control over the heater.

For AquaSwitch and JI2000:

The heater's thermostats still con-

trol the heater and should be

preset to the desired pool and

spa temperature. The pool/spa

select switch should be left on

pool mode and will be inactive

as the AquaSwitch or JI2000 has

switching control over the

heater.

Page 12