aquatherm AT-5000 설치, 사용 및 관리 매뉴얼 - 페이지 8

{카테고리_이름} aquatherm AT-5000에 대한 설치, 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aquatherm AT-5000 11 페이지. Aquarium chiller w/ heater outlet

UNIT PREPARATION AND OPERATION

2. Connecting Unit: Most likely you will be using a threaded barb fitting.

Connect fittings, 1" MPT, to port openings using a liberal amount of threaded

Teflon sealing tape or paste that is non-harmful to plastic.

NOTE: Do not over tighten fittings as this could result in cracking the

unit's factory fitting and cause leaking. Tighten fittings until just snug.

Set Chiller unit in desired location making sure it follows recommended

guidelines from previous section. Connect unit to aquarium system following

manufacturer's instructions and recommendations. The lower fitting is the

inlet water supply to the unit and the upper fitting is the outlet water supply.

Consult aquarium and pump owner's manual for directions on correct

guidelines for plumbing system. Check your piping connections. If reversed,

erratic operation will result. Do not install power cord or plug in unit until

instructed in next section. Turn on aquarium pump and circulate water

through system and chiller unit for at least 10 minutes to check for leakage.

NOTE: Make sure water lines and hoses do not drape over chiller unit

to insure water does not leak into unit. If leakage is detected, check

connection fittings on unit. If fittings are leaking, tighten 90° and retest

system. Repeat until no leakage is detected. If leakage is determined to

be coming from inside system, disconnect unit and contact a qualified

service representative.

3. To Operate the Unit follow these procedures:

a. Place unit power switch in off position

b. Place compressor/heater power switch in off position.

c. Locate unit power cord supplied and attach to rear of unit in the bottom

receptacle. Plug system heater (if used) into outlet on back of chiller unit.

Temperature controller of unit will automatically control both internal chiller

of unit and an external heat source.

Note: Check heater wattage for appropriate size.

d. Plug unit power cord into a 115V grounded outlet that is on a separate

circuit. Do not plug unit into a non-grounded outlet as this may cause

damage to unit and void warranty.

CAUTION:

minimum of 360 GPH and not more than 1100 GPH. NEVER

adthismanual

safetyand

OPERATE CHILLER/HEATER WITHOUT WATER FLOWING

lowedto insurey

THROUGH SYSTEM!

Make sure water is flowing through unit at a