Diamond Products MASONRY CC515M-E1 운영자 매뉴얼 - 페이지 2
{카테고리_이름} Diamond Products MASONRY CC515M-E1에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Products MASONRY CC515M-E1 7 페이지. Core cut masonry saw
페이지 인쇄SAFETY PRECAUTIONS
Failure to comply with following warnings could
1. Read and understand operator's manual before operating saw.
2. Keep guards in place and in good condition when saw is in operation.
3. Always wear approved ear, eye, head and respiratory protection.
4. Keep all parts of body away from blade and other moving parts. Do not touch or try
to stop a moving blade with your hand.
5. Know how to stop saw quickly in case of emergency.
6. Inspect blade, flanges, guards and arbor shaft for damage before mounting blade.
Verify blade arbor matches the machine arbor.
7. Only use blades marked with a maximum operating speed greater than blade shaft
speed. Read and understand warnings and instructions on the blade. Use the
correct blade for the type of work to be done. If you are unsure, check with the blade
manufacturer.
8. Use caution and follow instructions when transporting, lifting and setting up saw.
Always tie down the machine when transporting.
9. Keep bystanders and animals out of work area. Always keep work area clean, well
lit, and free from safety hazards.
10. Do not use saw or blade if damaged. Do not use a blade that has been dropped.
11. Do not operate saw near combustible material or wear clothing of combustible
material. Sparks from saw could cause fire or explosion.
12. Blade exposure should not exceed 180º.
13. Never leave saw unattended when running.
14. Never operate saw while under influence of drugs or alcohol.
15. Before refueling saws with gas engines, shut off engine and allow it to cool. Do not
smoke while handling fuel. Make sure the gas cap on the saw and fuel can are tight
before starting the saw.
16. Never operate gas engine in enclosed areas without proper ventilation.
17. Establish a training program for all operators of this machine and blade.
Note:
result in serious bodily injury!