Diamond Products MASONRY CC525M-E1 운영자 매뉴얼 - 페이지 4

{카테고리_이름} Diamond Products MASONRY CC525M-E1에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Products MASONRY CC525M-E1 7 페이지. Core cut masonry saw

페이지 인쇄

5. For Saws With Electric Motors:

Connect motor to a properly grounded outlet. Motor may be operated on 115 or 230

volts. Set switch on motor capacitor housing to match desired voltage. Plug on

motor cord must also be changed to match correct voltage.

Always make sure that motor is connected to a properly grounded outlet. Failure

to do so may result in serious bodily injury or death. Do not operate motor on low

voltage. It may cause power loss, overheating, or burn out motor windings.

Check voltage at motor while operating. Comply with all local electrical codes. If

Proper voltage is critical for proper motor performance. Extension cords which are too

long and/or too small of a gauge will prevent motor from receiving full voltage. Follow

extension cord recommendations below:

CORD

LENGTH

50 FT.

75 FT.

100 FT.

Turn switch to "ON" position to start electric motor. If motor overheats, the manual reset

thermal overload will trip. Turn motor off, wait 5-10 minutes for motor to cool, and push

reset button on capacitor housing. Button clicks to indicate that motor is reset.

For saws with gas engines:

Check engine oil level before starting. Start engine and allow it to warm up according to

engine manual instructions. After engine warms up, all sawing is done at full throttle.

To cut material, either:

a) Pull cutting head down by handle to desired cutting depth. It is best to use the entire

diamond segment height to cut. Tighten handle on depth lock to keep cutting head

at set height.

Take care not to saw conveyor cart in half. Cutting head pivot range allows

operator to "use up" an abrasive blade, but allows the risk of cutting

Do not allow material being cut to rub against blade flanges. This will damage

WARNING:

you are unsure, check with an electrician.

1.5 HP

115V

#12

#10

CAUTION:

conveyor cart.

CAUTION:

them and they will need to replaced.

230V

115V

#14

#10

#14

#10

#14

2.5 HP

230V

#14

#12