Diamond Systems JMM-5000-AK 사용자 설명서 - 페이지 14

{카테고리_이름} Diamond Systems JMM-5000-AK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Systems JMM-5000-AK 18 페이지. Advanced technology 218w dc/dc power supply pc/104-plus module
Diamond Systems JMM-5000-AK에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지)

페이지 인쇄

6.3

Output Power Connectors (J9 & J10)

Two screw terminal blocks are used for output power. J9 is a 7-pin block provides +5V and +5V standby output.

J10 is a 5-pin block and provides +12V, +3.3V, and +3.3V standby outputs. Following are the pinouts for the

mentioned connectors.

Connector J9:

Part Number: 1827910

Mating part Number: 1827758

Connector J10:

Part Number: 1827897

Mating part Number: 640621-2

6.4

Remote On/Off Control (J6)

A 2-position latching pin header can be used to connect a remote on/off signal to the power supply. This

connector is located along the right side of the board. An active low signal / contact closure between the input

and ground will turn off all outputs.

Part Number: 640457-2

Mating part Number: 1827732

JMM-5000 User Manual Rev B.00

Arrow.com.

Downloaded from

+5V out

GND

+5V standby

On/Off

GND

www.diamondsystems.com

J10

+3.3V standby

+12V out

+3.3V out

GND

Page 14