Diamond Systems JMM-5312-AK 사용자 설명서 - 페이지 17

{카테고리_이름} Diamond Systems JMM-5312-AK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Systems JMM-5312-AK 18 페이지. Advanced technology 218w dc/dc power supply pc/104-plus module

페이지 인쇄

7. INSTALLATION

All JMM-5000 power supplies are load tested prior to shipping. The power supplies ship with all the external

connectors required to start using your power supply immediately.

No user configuration is required for any version of JMM-5000. Simply plug in the input power and the supply is

operational. To power up your supply:

1. For protection, if you are unfamiliar with the use of this product, do not plug any other boards onto it

when powering it up for the first time.

2. Connect a DC source to the primary power input connector, J7, or to the secondary power input

connector, J8, if it is available. The supply will operate with input voltages from +7 to +34VDC.

CAUTION: Voltages above 35V will be shunted to ground through a transient voltage suppressor

(TVS) on the board. The TVS is rated for 1,500 watt surges. However it could be damaged by

sustained voltages above 35V.

3. Once the input voltage is in the valid range, verify that the proper power output indicator LEDs along the

lower edge of the board are illuminated. This verifies your input power connections and the power supply

is fully functional. Note that only indicators corresponding to the voltages available on the supply will be

lit.

4. Power down the supply. Plug the supply into your PC/104 stack. Your system is ready to use.

8. OUTPUT VOLTAGES AND CURRENTS

JMM-5000 provides output voltages based on the model and options ordered. The outputs appear on the

PC/104 bus headers J1 / J2 as well as on the output power connectors J9 and J10. The table below lists the

maximum ratings for each output voltage on each base Jupiter-5000 model.

** Optional special order option to add +3.3V at 5A, minimum order quantities apply

JMM-5000 User Manual Rev B.00

Arrow.com.

Downloaded from

Output

JMM-5012

+5V

20A

+12V

+3.3V

+5V standby

+3.3V standby

www.diamondsystems.com

JMM-5000

JMM-5312 *

20A

0.1A

Page 17