Panasonic DLP PT-DW530E 네트워크 매뉴얼 - 페이지 19
{카테고리_이름} Panasonic DLP PT-DW530E에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic DLP PT-DW530E 42 페이지. Dlp based projector
Panasonic DLP PT-DW530E에 대해서도 마찬가지입니다: 개요 (4 페이지)
페이지 인쇄Connecting with Wired LAN
Computer operation
Connection can be made with wired LAN. However, confirm to your system administrator on network settings
before changing any settings.
1
Turn on the computer.
2
Make the network setting according to your system administrator.
If the projector settings are the default settings (See page 11), the computer can be used with the following
network settings.
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
Connecting with Wireless LAN
You can configure settings when the wireless module (ET-WM200E/ET-WM200U) is mounted.
Projector settings
1
Turn on the projector and press the <NETWORK> button on the remote control.
2
Press the menu button to open the [NETWORK] menu, and then select from among
[USER1] through [USER3] for [WIRELESS LAN] and press <ENTER>.
3
In the configuration of wireless LAN, set [DHCP
[SUBNET MASK
[ENCRYPTION], and [CHANNEL]. For details, see "USER settings" of
"WIRELESS LAN" (See page 12).
"Glossary" (
See page 40 – 41)
_
Note
・
Wireless LAN and wired LAN cannot be used in the same segment.
・
When multiple devices are connected, a unique IP address must be allocated to each device.
・
SSID has to be entered in alphanumeric letters.
・
You cannot set "any" or "ANY" for SSID.
・
The following settings are set before the projector leaves the factory.
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
SSID
MODE
AUTHENTICATION
ENCRYPTION
CHANNEL
192.168.10.101
255.255.255.0
192.168.10.1
], [DEFAULT GATEWAY
_
OFF
192.168.11.100
255.255.255.0
192.168.11.1
Panasonic Projector
AD HOC
OPEN
NONE
11
], [IP ADDRESS
_
], [SSID
], [MODE], [AUTHENTICATION],
_
_
19
],
_