Panasonic DLP PT-DX500E 네트워크 매뉴얼 - 페이지 14

{카테고리_이름} Panasonic DLP PT-DX500E에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic DLP PT-DX500E 42 페이지. Dlp based projector
Panasonic DLP PT-DX500E에 대해서도 마찬가지입니다: 개요 (4 페이지)

페이지 인쇄

NETWORK menu (continued)

●

AUTHENTICATION

OPEN

SHARED

WPA-PSK

WPA2-PSK

●

ENCRYPTION

NONE

WEP

TKIP

AES

1: "Glossary" (

See page 40 – 41)

2: Available when the mode is set to [INFRASTRUCTURE].

Press [NEXT] after configuration is completed. Select [NEXT] if [WEP] is selected as the encryption method, and

select [STORE] if [OPEN] is selected. At this point, select [RETURN] to go back to the previous screen (1/2), or

select [CANCEL] to cancel the configuration change.

Note

・

IEEE802.1x is not supported.

・

Important video/audio data is protected because AES encryption processing takes place in advance for all

network numbers, even if [ENCRYPTION] is set to [NONE].

If [WEP] is selected as the encryption method, then perform the additional configuration below.

WIRELESS LAN

DEFAULT KEY

KEY1

KEY2

KEY3

KEY4

RETURN

STORE

CANCEL

MENU SELECT

CHANGE

●

When setting [OPEN] or [SHARED] as authentication and setting [WEP] as the encryption

method:

DEFAULT KEY

KEY1 – 4

●

When using [WPA-PSK] or [WPA2-PSK] : Set key and select [OK].

Note

・

If you are unable to connect to the wireless LAN through the access point even after performing the steps in

"Projector settings (See page 19)", contact the manufacturer of the access point.

：Set the user authentication method used by the network to be connected.

：Select when making a connection using [AD HOC], or when the access point

authentication method is OpenSystem

：Select when making a connection using [AD HOC], or when the access point

authentication method is Shared Key

：Select when the access point authentication method is WPA-PSK

：Select when the access point authentication method is WPA2-PSK

：Select the encryption method to be used for communication between the

projector and the network.

：Select when transmit without encryption. It is selectable only when

[AUTHENTICATION] is [OPEN] or [SHARED].

：Select when ENCRYPTION is WEP.

：Select when ENCRYPTION is TKIP.

Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].

：Select when ENCRYPTION is AES.

Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].

3/3

：Set 1 – 4 numerals for the default key.

：Set these to match the WEP key registered in [DEFAULT KEY] and select [OK].

Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key, input five

alphanumerics (or a 10-digit string for the hexadecimal format) for the 128-bit key,

input 13 alphanumerics (or a 26-digit string for the hexadecimal format).

Input either 8 to 63 alphanumerics or a 64 digit string in the hexadecimal format.