Panasonic et-jpc100we 설치 지침 매뉴얼 - 페이지 26

{카테고리_이름} Panasonic et-jpc100we에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic et-jpc100we 28 페이지.

Installation (continued)

360°

3) Tighten the ﬁ xing screws.

 While supporting the main unit, securely tighten the rotating ﬁ xing screw and two ball joint ﬁ xing screws

with the allen wrench (3.0 mm [1/8"] across ﬂ ats) supplied with the projector.

Attention

 The main unit and power supply section of the projector are connected by a cable, etc. Do not rotate and

change the tilt of the main unit more than necessary.

Attention

 The rotating ﬁ xing screw and ball joint ﬁ xing screws are hexagon socket head screws (M6). Take care because

they will come out of the projector if loosened too much.

 After making rough adjustments, refer to the operating instructions of the projector and then ﬁ nely adjust the

projection position, focus, and projection screen size while actually projecting images. If necessary, also correct

any keystone distortion.

26 - ENGLISH

Ball joint movement range:

Approx. 90°

 When you loosen the two ball joint ﬁ xing

screws, the ball joint can move freely.

This allows you to rotate the main unit 360° or

tilt the main unit 90° with the ball joint moving

part.