Panasonic ETJPC200BU 설치 지침 매뉴얼 - 페이지 22

{카테고리_이름} Panasonic ETJPC200BU에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic ETJPC200BU 30 페이지.

Installation (continued)

Mounting the projector to the attachment plate

Attach the projector mounted with the projector mount bracket to the attachment plate that already installed to the

wall or ceiling.

r Install the projector to a wall

Attention

z For wall mounting, set the pole of the projector at the upper end and the lengthwise direction of the power

supply unit vertically, and then perform the mounting work.

Ball joint fixing screw

Projector mount bracket

22 - ENGLISH

Shaft

Groove

Attachment plate

Shaft

Groove

1) Change the orientation of the main unit of the

projector.

z Refer to "Changing the orientation of the main

unit of the projector" ( page 19), adjust the

orientation of the main unit of the projector as

shown in the left illustration and then fasten the

ball joint fixing screw.

2) Attach the groove of the projector mount

bracket to the shaft of the attachment plate.

Warning:

The mounting and installation must be carried out

by two or more persons.

3) Attach the projector mount bracket to the

attachment plate.

z Slide the projector mount bracket as shown in

the left illustration and make the groove of the

projector mount bracket held on to the shaft of

the attachment plate.

Attention

z Do not release your hand until the shaft of the

attachment plate is fitted into the groove of the

projector mount bracket.