Panasonic PLC-XP40 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Panasonic PLC-XP40에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PLC-XP40 44 페이지. Multimedia projector

페이지 인쇄
Panasonic PLC-XP40 소유자 매뉴얼
ZOOM BUTTON
Used to adjust zoom.
(P20)
FOCUS BUTTON
Used to adjust focus.
(P20)
MUTE BUTTON
Used to mute sound.(P21)
NO SHOW BUTTON
Used to turn picture into
black image. (P21)
AUTO PC ADJ. BUTTON
Use to operate AUTO PC
Adjustment function. (P23)
WIRED REMOTE JACK
When using as Wired
Remote Control, connect
Remote Control Cable to
this jack.
Battery installation is
required when using as
Wired Remote Control.
Remove battery
1
compartment lid.
Press lid down-
ward and slide it.
To insure safe operation, please observe following precautions :
Use (2) AA, UM3 or R06 type alkaline batteries.
Replace two batteries at same time.
Do not use a new battery with an used battery.
Avoid contact with water or liquid.
Do not expose Remote Control Unit to moisture, or heat.
Do not drop Remote Control Unit.
If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
Danger of explosion if battery is incorrectly replaced.
Dispose of used batteries according to batteries manufacturers instructions and local rules.
ON-OFF
VOLUME BUTTON
ZOOM
FOCUS
VOLUME
Used to adjust volume.
(P21)
D.ZOOM
MUTE
INPUT
D.ZOOM BUTTON
Used to select DIGITAL
ZOOM +/– mode and
MENU
resize image. (P29)
LENS SHIFT BUTTON
Used to select LENS
SHIFT function. (P20)
LASER
LENS SHIFT
FREEZE BUTTON
Used to freeze picture.
KEYSTONE
(P21)
NO SHOW
FREEZE
AUTO PC ADJ.
IMAGE
Used to select image
P-TIMER
level. (P27, 32)
KEYSTONE BUTTON
Used
keystone distortion.
(P20, 35)

Remote Control Batteries Installation

Slide batteries into
2
compartment.
Operating Range
Point Remote Control Unit toward
projector
whenever pressing any button.
Maximum operating range for
Remote Control Unit is about 16.4'
(5m) and 60° in front and rear of a
projector.
16.4'
(5 m)
IMAGE BUTTON
to
correct
Two AA size batteries
For correct polarity (+ and
–),
be
sure
battery
terminals are in contact
with pins in compartment.
BEFORE OPERATION
(Receiver
Window)
60°
16.4'
(5 m)
60°
Replace compartment lid.
3
15