Panasonic PT-61D31CE 서비스 매뉴얼 - 페이지 7
{카테고리_이름} Panasonic PT-61D31CE에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-61D31CE 18 페이지. Color video projection system
페이지 인쇄Note: Set the 30% modulation with the Pilot Light
and N.R. switches "OFF" then turn them "ON"
while testing.
5. Adjust MTS High-Level Separation (S08) data until
the amplitude of the waveform measured on the
scope is minimum.
6. Repeat above steps 2 through 4 until the amplitude
is at minimum for both signals.
Clock Adjustment (S12)
Preparation:
Connect a frequency counter from IC001 MPU Pin
34 or TPA39, to cold ground (
Note: Frequency Counter probe capacitance should
be 8pF or less.
Procedure:
1. Turn the PTV "ON" with the AC power applied.
2. Measure IC001 MPU pin 34 for frequency and
record the reading.
Note: Pin 34 measurement must have at least four
digits of resolution following the decimal point.
Example: 000.0000
3. Place the PTV into Service Mode for making
electronic adjustment, select the Clock Adjustment
DAC (S9) and change value to 128.
4. Calculate
and
set
following formula:
(
)
6
S
=
128
+
09
1.35 x 10
Note: Pin
34
measurement
regardless of the value stored in S09.
).
S9
based
on
{
(
) Hz
[
]
pin
187.5000
–
34
-------------------------------------------------------------------
x
187.5000
will
not
change
PIP Adjustment (TPY2)
Preparation:
1. Apply a color bar pattern.
2. Connect scope to connector A20 pin 2 on A-Board
or connector Y1 pin 2 (TPY2) on Y-Board.
3. Turn PIP on.
Procedure:
1. Adjust DAC P03 (PIP Contrast) until child
waveform level is 90% of parent waveform level.
See Fig. 12.
WHITE
Parent
A
BLACK
Figure 12. Parent and Child Y
the
}
- 15 -
P-Y
Child
C-Y
Ax0.9
Service Manual