Panasonic PT-65WX50 사용 설명서 - 페이지 6

{카테고리_이름} Panasonic PT-65WX50에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-65WX50 36 페이지. Color video projection system
Panasonic PT-65WX50에 대해서도 마찬가지입니다: 사용 설명서 (37 페이지), 사용 설명서 (34 페이지), 사용 설명서 (36 페이지)

페이지 인쇄
Panasonic PT-65WX50 사용 설명서
INSTALLATION
Installation
Television Location
This unit can be used as part of an entertainment center.
Consult your dealer for available
options.
O
Avoid excessive sunlight or bright lights, including reflections.
O
Keep away from excessive heat or moisture.
Inadequate ventilation may cause interna!
component failure.
O
Fluorescent lighting may reduce remote control transmitting range.
O
Keep away from magnetic equipment, including motors, fans, or external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between components. For best results:
O
Use 75-ohm coaxial shielded cables.
O
Use appropriate input and output connectors that match your component connectors.
O
Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT.
DO NOT
Polarized Plug
USE A PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
t=
Cable / Antenna Connections
For proper reception, either a cable or antenna connection is required.
Cable Connection
Incoming Cable from
i
Cable Company
Connect the cable supplied by your local cable company to ANT1
connection on back of television. Select cable mode and ANT1 in SET UP
iy
menu under Prog Chan (Program Channels).
@ Cm
Note:
A cable converter box may be required for proper reception.
Check
with
your
local
cable
company
for
compatibility
requirements.
75 Ohm VHF/UHF
on back of TV
Antenna Connection
a
For proper reception of VHF/UHF channels, an external antenna is required. For
best reception, an outdoor antenna ts recommended.
°
Connect home antenna to back of television. Select TV
mode and ANT1 in the SET UP Menu under Prog Chan.
Incoming Cable from
X
/ Fa
Home Antenna
SWS Cable Preset
Qo
Cabte
Mode
is preset
at the
factory.
Antenna users must change to TV Mode and
Pi
ANT1 in the Set Up Menu under Prog Chan.