Panasonic PT-AE4000 기능별 지침 - 페이지 14
{카테고리_이름} Panasonic PT-AE4000에 대한 기능별 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-AE4000 50 페이지. Projector lineup
Panasonic PT-AE4000에 대해서도 마찬가지입니다: 사양 시트 (10 페이지)
페이지 인쇄
Remote control operation
Loading a saved setting
You can access saved settings instantly. See
"MEMORY LOAD" on page 31.
VIERA Link
You can control some functions of the connected equipment with this projector remote control.
See the operating instructions for more details.
Adjusting the signal condition with a waveform
You can display the image brightness and
contrast level of the input signal with a
waveform. See "WAVEFORM MONITOR" on
page 21.
FULL SCAN
SINGLE LINE SCAN
Displaying the waveform
J
1.
Press the
WAVEFORM MONITOR button and
display the waveform monitor.
Press the WAVEFORM MONITOR button again to
escape from the waveform mode.
NOTE:
•
In
SINGLE LINE SCAN mode, the position of the waveform monitor depends on the position of the selected line.
•
You can display the main menu by pressing the
•
The called up menu items displayed position depends on the position of the waveform monitor.
•
You can activate
•
The signal which is lower than 0 % in the waveform will be displayed as same as 0 % on the projected image.
•
While the waveform is displayed, you can not adjust the
Capturing an image
Press the FREEZE button to capture the
image, and you can see it as a still picture
while the AV equipment are still running. Press
the FREEZE button again to escape and return
to the continuing image.
Resetting to the factory default settings
You can reset most of the customised
settings to the factory defaults by pressing
the DEFAULT button. Display the required
sub-menu or the menu items and press the
button.
E
14 -
NGLISH
Monitoring the waveform of
brightness and contrast of the whole
image.
Monitoring the waveform of
brightness and contrast in each
horizontal line of the image.
AUTO ADJUST of the WAVEFORM MONITOR menu by pressing the DEFAULT button.
1.
Select the required setting from
Undefined setting will not be displayed.
2.
Press the
setting.
NOTE:
•
If you have not saved any settings,
will not be displayed.
2.
Press the
waveform option is displayed.
In FULL SCAN mode, press ▲ ▼ ◄ ► to change
the waveform position.
In SINGLE LINE SCAN mode, press ▲ ▼ to select
the required line position.
FULL SCAN(Y)
FULL SCAN(R)
FULL SCAN(G)
FULL SCAN(B)
MENU button and adjust the menu items.
COLOUR MANAGEMENT settings.
While displaying the frozen image, you can enter the
AREA SELECT mode of the SPLIT ADJUST menu by
pressing the ENTER button. See "SPLIT ADJUST" on
page 22.
NOTE:
•
Some menu items are not available to reset by
pressing the DEFAULT button. Adjust each menu item
manually.
MEMORY 1 - 16.
ENTER button to activate the selected
MEMORY 1 - 16
ENTER button until the required
SINGLE LINE SCAN(B)
SINGLE LINE SCAN(G)
SINGLE LINE SCAN(R)
SINGLE LINE SCAN(Y)